![]() ![]() Most keypads have holding screws at their bottom center. Before the last step, locate the keypad holding screw to remove the screw-holding keypad.Unplug the keypad power cable and remove the holding screws: Remove leads from the transformer with the use of a flathead screwdriver. Like a base unit transformer, it also has leads connected to its bottom. Hold the transformer carefully then unplug it from the outlet.have your flathead screwdriver, then remove the screw holding the transformer. As we discussed in the first step, we will remove the keypad transformer after removing the base unit from the wall.Once the screw and cover will be removed, remove the battery. After it, slide the battery holder back.Use your Phillips screwdriver and start Loosening the battery screws. In the last step of removing the base unit, you have to remove the battery from the unit.Remove the battery from the base unit system: Once the mounting unit would be lifted, remove the back cover from the wall. Take your flathead screw and remove the back cover screw. Now, You have to remove the cover screws to lift the init of the mount.Unplug the ethernet cable and power cord. You will find them on top of the system device. Two plug-type wires will be connected to the unit system box.Next, Unplug the cable, and code, and remove the back cover: There will be two power leads connected to the transformer that appears like red or blue wires, and after unplugging the transformer, remove those leads. Hold the transformer and Unplug it safely. Pick your flathead screwdriver, find the screw holding the transformer and remove the screw.Take care of transformer type since keypad transfer should be unplugged after the base unit transformer. The transformer will be plugged in near the outlets. As the base unit requires lower power voltage, it has a transformer attached to it via wire.First, Remove the transformer of the base unit: Slide the back cover and remove the keypad battery.Unplug the keypad power cable and remove the holding screws.Remove the battery from the base unit system.Unplug the cable, code, and remove the back cover.Remove the transformer of the base unit.Here’s How to Remove an ADT Panel from Wall: In the process, we will remove the ADT panel system by drawing the base unit first and then the keypad. Don’t try to be quick, as the process will costume a few minutes. It may take 7 to 15 minutes to remove the entire system. This process can be done in a few minutes, but as you are doing it for the first time, proceed slowly to avoid any mistakes. Make sure both types of screwdrivers are in a good state, and also that their handles cannot conduct power as, in some steps, we have to open parts. Only two types of tools are required to complete the process A Phillips head screwdriver and a small flathead screwdriver. Slide the back cover and remove the keypad battery: The Time and Tools you need to Remove A Adt Panel from Wall:.Unplug the keypad power cable and remove the holding screws:. ![]() Remove the battery from the base unit system:.Next, Unplug the cable, and code, and remove the back cover:.First, Remove the transformer of the base unit:.Here’s How to Remove an ADT Panel from Wall:.The Time and Tools you need to Remove A Adt Panel from Wall:. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |